Is there anyway to hook up two car battery chargers in series to get a very high current? - battery chargers
I have two chargers and car that you use as an energy source in an electrolytic cell. Is there a way to switch both connected in series to double the current and voltage?
Thank you in advance.
Friday, December 11, 2009
Battery Chargers Is There Anyway To Hook Up Two Car Battery Chargers In Series To Get A Very High Current?
Subscribe to:
Post Comments (Atom)
3 comments:
She did not say exactly what you're thinking, but the shipper is not eating the power cable are the power supply. Chargers simply contact their power 110/220VAC to 12VDC nominal. If the device requires a high power source of 12 VDC, you probably want the same sender, you create a car battery.
If these boots well designed and rated at 12 V DC at 20A can be connected in series to produce up to 24VDC at 20A or parallel to produce 12VDC at 40A combined. But if you connect both a 110V 15A circuit to connect to, disconnect the power switch in both cases.
In parallel to double the power at the same voltage in the series will receive a stream (the lowest, if not equal) to double the voltage.
But most chargers are equipped with circuits to regulate the amount of cargo, and cut it when the battery is fully charged. The circuit does not function properly when connected in parallel or in series.
.
In parallel to double the power at the same voltage in the series will receive a stream (the lowest, if not equal) to double the voltage.
But most chargers are equipped with circuits to regulate the amount of cargo, and cut it when the battery is fully charged. The circuit does not function properly when connected in parallel or in series.
.
Post a Comment